I'm at a loss on how to support this one. No matter how I orientate it, there is text pointing down somewhere creating nasty overhangs that adding supports to would ruin the text.
It will be a 6+ hour print so, I didn't want to do my usual "support and pray" technique, although I have learned a lot that way
Figured, I'd post it up here to see if there are any ideas before I send it to Stuller and have them CAM and cast it, lol.
Any help is, as always, much appreciated.
Link to stl
Any idea on how to support this?
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Any idea on how to support this?
Ha. The text that's all over the sides kinda make things more difficult. I think you just need to support it as is. Standing up. Put lots of supports on the bottom, following the curvature and then some supports on the inside to support the middle. If your text is creating overhangs, those need to be supported also, which can be a challenge in this case, but doable.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Any idea on how to support this?
Thanks, Monger. You just gave me the courage to try it.
Stay tuned for updates
Stay tuned for updates
Re: Any idea on how to support this?
KennyB wrote:Thanks, Monger. You just gave me the courage to try it.
Stay tuned for updates
Once i had a problem with a ring that need it to much supports so i built an inner ring and send it after. What about doing an outer ring
Re: Any idea on how to support this?
This had words all the way around it too. I used the support creator from B9 and made my tips .25mm and went to town. I use a sharp scalpel and removed the supports before they had been cured.
I really don't have any dogs. But the insatiable urge to fit in has caused me to do a dog avatar!
Who is online
Users browsing this forum: No registered users and 93 guests