Film marking and build support problem

[dcpattni]

i'm still searching locally back UPS of 1kva.....i'm searching good UPS.....
Using VGA cable.
i checked preview it was looking ok.

[dcpattni]

same file seems came out ok attached images...will clean with soap & water in ultrasonic and 3 mins microwave 10 mins cool down 3 times......why it don't get harder like yr Solus samples!!!

it's means main power supply MARK said it's correct...

very very slightly design marks on film..

[M-Williams]

I have experience a screen saver trick that sliced my work like yours. it is a power related.

[dcpattni]

why can't we use Form-lab(preform) for auto support as they make better then B9 I personally feel.

I save as supported but unable to open in SC it don't show.

[Jewelermdt]

Only if you can save as an STL file. It's one way they can protect their product.

[mongerdesigns]

why can't we use Form-lab(preform) for auto support as they make better then B9 I personally feel.

I save as supported but unable to open in SC it don't show.

Ask formlabs.

[dcpattni]

1. When did Ganesha (my first time on 25xy) it was super cool no
problem. i did abt 4 time now @ 80x45 not coming nice some area gets very thin
and some part not growing.

2. pendant i think its bçoz of support?

3 layers are easy to notice....i removed resin from film which part did not grow but grow on film.

attached images

[dcpattni]

as advice by Mark i managed successful. important abt support how to set....and changed some parameter done 20 micron. attached images

[dcpattni]

setting screen short.
I''m still learning
THANK YOU VERY MUCH MARK!!!

[reify]

You're doing very well, Dipen. Try without the supports on the sides next time, I don't think they're necessary.