Page 1 of 1
Failed Prints
Posted: Tue Oct 11, 2016 5:32 pm
by RSpangler16
So I've been having some issues here. I am not sure if it is my supports or my printer settings. Recently I found the suggested calibration settings for the InFocus projector and then refocused the grid and it seemed to help a bit, but some smaller details are still not coming out. I have gotten excellent detail before on much smaller components so I think it is either the printer settings or the resin.
The first two images are of failed print 1, the third is of failed print 2.
Re: Failed Prints
Posted: Tue Oct 11, 2016 5:33 pm
by RSpangler16
Sorry the first and third image are of the same print, the middle one is a second print. The second time I lowered the object to the base to try to eliminate some supports.
Re: Failed Prints
Posted: Tue Oct 11, 2016 5:43 pm
by reify
Hi,
Can you email the stl to
reify3d@gmail.com?
Re: Failed Prints
Posted: Tue Oct 11, 2016 5:47 pm
by mongerdesigns
Looks like a support issue. Every time you have horizontal area overhangs, you need to support them well, or tilt the model slightly to eliminate those areas.
Re: Failed Prints
Posted: Tue Oct 11, 2016 8:15 pm
by RSpangler16
Thanks for the quick response guys, I really appreciate it!
Re: Failed Prints
Posted: Sat Nov 19, 2016 7:40 am
by Kerstien
I would printed upright