Page 1 of 1
Help!!! Build arm stuck at Z
Posted: Tue Jan 17, 2017 8:56 pm
by kharness
Hello -
So my printer was about to print then an error popped up and now my build arm is stuck at Z. How do I get this think to move?
thanks, Kevin
Re: Help!!! Build arm stuck at Z
Posted: Tue Jan 17, 2017 9:15 pm
by mongerdesigns
Turn off the power from the switch in the back. Then by hand slowly turn the Z screw until you lift the arm enough so that you can slide the build table and tank out together. Reset everything, clean, and give it a go again.
Make sure to touch something metal before touching the printer. It's possible that static buildup caused the printer to disconnect from the USB. Try a different USB port and/or cable.
Re: Help!!! Build arm stuck at Z
Posted: Wed Jan 18, 2017 9:31 pm
by kharness
thanks, everything seems to be working fine now.
kevin