What happen went no print in the plate?

[MDLEON]

How Know the weight for resine to gold or silver thanks for the support.

[Archerm]

Did you go through the setup and go through the full RGB setup? Did you remove the filter on the projector? What resin are you using?

[reify]

Hi,

May I ask where you are located?

As Archerm asked, did you remove the UV filter?

[MDLEON]

Thanks for your reply, I used B9 yellow, everything come half and no come!

[MDLEON]

Yes I remove the uv from inside the first time to set up.

[MDLEON]

We are I found the RGB I have windows 10, thanks for your support.

[M-Williams]

Just follow the basic initial steps. don't try to rush your calibration process. you will be printing high end prints in on time.

[Gtg330]

I had a couple that didn't show up on grow plate. The plate needs to be sanded up so it's no soo smooth so the resin does no stick. And you printed something but no print on plate check you resin tank bottom for start plate the is on bottom then nothing on future will how in that area because curing light is being blocked.

[rkundla]

It appears your question has changed. Unless you know the specific gravity of the resin in question, I generically use a s.g. of 1.1 in my calculations to normalize it, then use the s.g. for the metal in question to get your metal weight.