Hi,
Today I have printed two 10mm Cube on the same platform and got the following result-
Cube- without support
X-9.86mm Y-9.75mm Z-9.57mm
Cube- With support
X-9.84mm Y-9.74mm Z-10.25mm
Why Cube printed with support get dimension in z direction got so high. I need your support to get more accurate result.
Regard,
Kamal Soni
My test print...
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: My test print...
Most likely some residual resin curing occurs on the bottom of the cube where the supports attach. This is mostly true with transparent resins like the yellow.
So could be that what you're measuring is some extra resin that's cured on the bottom surface of the cube.
So could be that what you're measuring is some extra resin that's cured on the bottom surface of the cube.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 9 guests