Reify3D Forum

Emil , would you recommend including the sprues to be grow in the file with this resin ??

Sure, you can do that. But might take longer to grow depending on the position of your sprue.

also , will contour ever have an option for not raising or limiting the heith of the tallness of the grow, I mean being able to control the height of the model being raised and adding more time to the grow , or is that height been shown to have the most success rate as a result ??

dcpattni wrote:@ mongerdesigns,

Request can you plz try with new resin (SOLUS blue resin) ring which I posted......also share supports sizes etc.

Don't have much time but it was interesting to see how it would pull it off. No sweat. The support tips are the smallest at 0.1 and automatic supports were used.

Hope you don't mind if I take this print to the JCK

https://instagram.com/p/BUnuJ8lDMSN/

That's sooo coool!

Now perfect casting and you have a winner!!
Can't wait to have the blue stuff...

@ mongerdesigns

Print is wow wow wow.....and autosupport @0,1mm is also wow!!!!!
i don't mind atall.....thank you very much for trail print.

I love my Solus printer!!!.

You can't go wrong with countour. you need just to pay attention to any overhang .

hi,

after suggestion from SOlUS users experts i try as below:-

1st try single ring white 0.1mm support which print good easy to removed supports but bottom(dome area) prongs it was not perfect.

2nd try in 2 parts as Mr.Sam advice, it worked very clear but top front only it did not print well....but rest was clean & clear images below.

3rd try with 0.2mm only for Dome it didn't grow....

All suports are manualy.

I always mix b9 very very well before filling in VAT.

what do you think........i m doing few other printing going OK....only this ring mirco prongs giving tuff time.

clearly seen dome area prongs are not good.