I'm currently setting back up a solus that has sat unused for 2 years. The outside had a significant amount of dust on it , both the projector and the printer. I am wondering if there is a recommended cleaning process for internal projector optics as well as the printer internals? I imagine with so much dust some has definitely gotten inside both machines and I'm afraid it will effect prints if not cleaned. I cleaned the lense of projector but it appears there is a small piece of dust on the inside of the lense. I was hoping to at least try and blow away dust but wondering if those surfaces can be wiped? Also curious about cleaning mirror on inside of printer. I'm wondering how that's done and is there a risk of throwing off mirror alignment?
Thanks for any advice
Topics about Solus 3d Printer's hardware
1 post •Page 1 of 1
Who is online
Users browsing this forum: No registered users and 11 guests