Kris
If I'm getting great prints I will not remove my vat and home with it on. I do not tighten my vat that much. Iv'e never had a problem. BUT never home with the platform on.
Stuck on home cycle, motors won't turn
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Stuck on home cycle, motors won't turn
This is a dumb question perhaps....but should we all upgrade the tilt motor just in case? Better yet, how can I tell I have the old tilt motor?
My printer is working fine though. Probably shouldn't mess with it. LOL
My printer is working fine though. Probably shouldn't mess with it. LOL
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Stuck on home cycle, motors won't turn
If you look into the printer from the top window, towards the left tilt side, you can see the motor. If the motor screw has a plastic tip then it’s the old motor. The new motor is all metal.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 16 guests