Page 1 of 3
(SOLVED)NVIDIA RGB ISSUE
Posted: Sat Apr 15, 2017 7:21 pm
by ironfonzy
Hello !
I think i have a problem with RGB issue and nvidia...At these time as you can see here's my first test...
I have geforce770..i install the latest driver for it and hope solve the problem.....
thanks if you have any suggestions..
Re: NVIDIA RGB ISSUE
Posted: Sun Apr 16, 2017 1:58 am
by Jewelermdt
That does not look like the Nvida Control panel. Right click on you screen and see if the Nvida properties tab comes up.
Re: NVIDIA RGB ISSUE
Posted: Sun Apr 16, 2017 4:00 am
by mongerdesigns
You have too many things (monitors) connected to your PC.
When we say you need a dedicated computer for the Solus, it's not a light suggestion
Re: NVIDIA RGB ISSUE
Posted: Sun Apr 16, 2017 8:01 am
by ironfonzy
mongerdesigns wrote:You have too many things (monitors) connected to your PC.
When we say you need a dedicated computer for the Solus, it's not a light suggestion
ok i will try without my cintiq so..hope it will solve my problem..thanks for help talk to you soon
Re: NVIDIA RGB ISSUE
Posted: Mon Apr 17, 2017 7:43 pm
by ironfonzy
Re: NVIDIA RGB ISSUE
Posted: Mon Apr 17, 2017 7:54 pm
by samatheang
I don't see any RGB issue with your failed print. You should post some pic of the supported model that you are trying to print. Look like support issue.
Re: NVIDIA RGB ISSUE
Posted: Mon Apr 17, 2017 8:06 pm
by ironfonzy
These is the ultra complex model
if i have not rgb problem why the first slice is ok and not the others ???
Re: NVIDIA RGB ISSUE
Posted: Mon Apr 17, 2017 11:48 pm
by samatheang
You should try to re-calibrate your build platform by following the video here:
https://reify3d.wistia.com/projects/ztww6a0tqj Also, you should tilt the model about 25 degree and support it well. Don't just rely on auto support.
If it is RGB problem, you will see the whole build area got cured, but your picture shows only the model and support area got cured.
ironfonzy wrote:These is the ultra complex model
if i have not rgb problem why the first slice is ok and not the others ???
Re: NVIDIA RGB ISSUE
Posted: Tue Apr 18, 2017 12:53 am
by Jewelermdt
I would just put that model in contour and use NO supports. Or do both one with and one without. Make sure your support tips are big enough to support the model.
Is anything else running on the computer? No screensaver, No idle setting, No hibernating. You can NOT do any other work with computer while printing. Reason why it's suggested you get a separate computer to run the Solus.
Re: NVIDIA RGB ISSUE
Posted: Tue Apr 18, 2017 12:54 am
by mongerdesigns
Have you removed the UV filter from your projector? It's a little square glass in-front of the projector bulb assembly. It's in the instructions.
