[SOLVED] Solus will not perform homing cycle

[wawatobi]

Tried to print tonight and the solus would not perform the homing cycle. I cancelled the print and went to the set up. I clicked connect to printer and that seemed to work but when I click homing cycle I get nothing.??

[Jewelermdt]

Are you running CW or Contour. Can you run Z up and down? Is the Z drive movable when powered off? Try different usb port.

[reify]

I'll email you now to debug the issue.

[Biceps]

How was this solved? I had this problem suddenly appear right after i updated my ver 1.4 to 1.6. After hours of troubleshooting I downgraded back to 1.4. Still didn't work, left to get something to eat and came back and was suddenly working

Yep, I tried in CW also; I could only get it to home after re-plugging the usb cable. After that, couldn't do anything.