Page 1 of 1
[SOLVED] Solus will not perform homing cycle
Posted: Fri Jun 16, 2017 1:31 am
by wawatobi
Tried to print tonight and the solus would not perform the homing cycle. I cancelled the print and went to the set up. I clicked connect to printer and that seemed to work but when I click homing cycle I get nothing.??
Re: Solus will not perform homing cycle
Posted: Fri Jun 16, 2017 1:47 am
by Jewelermdt
Are you running CW or Contour. Can you run Z up and down? Is the Z drive movable when powered off? Try different usb port.
Re: Solus will not perform homing cycle
Posted: Fri Jun 16, 2017 2:59 am
by reify
I'll email you now to debug the issue.
Re: [SOLVED] Solus will not perform homing cycle
Posted: Sat Aug 05, 2017 8:56 pm
by Biceps
How was this solved? I had this problem suddenly appear right after i updated my ver 1.4 to 1.6. After hours of troubleshooting I downgraded back to 1.4. Still didn't work, left to get something to eat and came back and was suddenly working
Yep, I tried in CW also; I could only get it to home after re-plugging the usb cable. After that, couldn't do anything.