Contour 1.9.0.0
The new upgrade grid calibration is is awesome!!!!
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Contour 1.9.0.0
@Weaver The light intensity should only affect exposure. As your bulb ages you may need to increase it. If you get a lot of flashing you might want to decrease it.
Love the easy gird adjustment.
Love the easy gird adjustment.
Re: Contour 1.9.0.0
mongerdesigns wrote:
No, you cannot force to put a support tip on a surface that is pointing upwards, because that would be counter effective.
well there have been cases, let's say a long sword or a vehicle antenna that consist of a long thin geometry pointing diagonally up and would benefit from a few extra support tips so as not to wobble
Re: Contour 1.9.0.0
If it needs support or if there is worry about wobble, which there shouldn't be any, then change the angle of the model so that the sword/antenna is at an angle. You'll get overall better layering and you can add supports on flat parts where needed.voudas wrote:well there have been cases, let's say a long sword or a vehicle antenna that consist of a long thin geometry pointing diagonally up and would benefit from a few extra support tips so as not to wobble
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Contour 1.9.0.0
Or do what I do and build them into the model.
Re: Contour 1.9.0.0
guys ty for the tips, of course that is what i already do, i design custom supports (other orientation on some models is not an option) BUT if there is a way to do our life easier or faster, why not?
Who is online
Users browsing this forum: No registered users and 4 guests