Hello,
Today back to my workshop 2h after launching my 3d print, no cured resin stuk in the platform.
So I had this idea of a checkbox "Move up the platform during the first minutes" in order to check the print is starting well.
It's so frustrated to find out the print has failed since the begining.
Jacques
Contour Feature Idea about failed print
Re: Contour Feature Idea about failed print
You can do that by clicking the Pause button during print.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Contour Feature Idea about failed print
Yes. Just press the pause button and then resume button to continue printing.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Contour Feature Idea about failed print
Thank you for this trick.
I hope this failed print was from a film issue.
I hope this failed print was from a film issue.
Who is online
Users browsing this forum: No registered users and 9 guests