Contour Feature Idea about failed print
Posted: Thu Mar 01, 2018 7:48 pm
Hello,
Today back to my workshop 2h after launching my 3d print, no cured resin stuk in the platform.
So I had this idea of a checkbox "Move up the platform during the first minutes" in order to check the print is starting well.
It's so frustrated to find out the print has failed since the begining.
Jacques
Today back to my workshop 2h after launching my 3d print, no cured resin stuk in the platform.
So I had this idea of a checkbox "Move up the platform during the first minutes" in order to check the print is starting well.
It's so frustrated to find out the print has failed since the begining.
Jacques