CW platform size
-
- Novice
- Posts:27
- Joined:Mon Apr 25, 2016 10:29 pm
Can CW platform work area be enlarged? My current area is about 20 X 30 mm.
Re: CW platform size
yes, i am currently printing at 30u XY. i am using the 10x, and my build area is 58x by 32y. you will have to adjust zoom, and calibrate based on something of a known size. i use a 25mm cube.
Re: CW platform size
Wdshea wrote:yes, i am currently printing at 30u XY. i am using the 10x, and my build area is 58x by 32y. you will have to adjust zoom, and calibrate based on something of a known size. i use a 25mm cube.
how is your minimum prong size with this
Re: CW platform size
none of what i print has prongs, we're not doing gems yet. positive details are much easier than negative, but i'd be willing to bet you can print any prong size.
Re: CW platform size
Wdshea wrote:none of what i print has prongs, we're not doing gems yet. positive details are much easier than negative, but i'd be willing to bet you can print any prong size.
ah, my question is about minimum support size, i had test, 0.35 is ok with 55x31 size. Very good
Re: CW platform size
i print supports down to .3, but they are intermediate (the base is connected to the part itself) and they are also short. when i print supports like that, i also make them cylinder all the way, and straight. i use b9 software.
Who is online
Users browsing this forum: No registered users and 3 guests