I'm trying to print a cuff but am getting a print fail parameter incorrect. I tried to slice preview but get the parameter incorrect error there as well. Not sure what the parameter is, but obviously it's incorrect. Anybody know what can be done?
It's a large stl but I did run it through netfab and it's clean.
thx
Parameter incorrect
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Parameter incorrect
Does the cuff fit TOTAL inside the gird pattern. Not sure how you check height limit. Not sure with Contour, but with CW it would show red if it was outside the print area.
Re: Parameter incorrect
Yes, it does fit in the Contour print area. I'll take a screen shot and paste later today and also try to send the stl as well.
Thank you
Jim
Thank you
Jim
Re: Parameter incorrect
So here's the funny thing. I tried slice preview before using the manual supports in Contour (automatic locked up my low power laptop) and it sliced perfectly. Then put in some manual supports and that's when the parameter error pops up. So, it has to be the supports in Contour.
Re: Parameter incorrect
printcast wrote:So here's the funny thing. I tried slice preview before using the manual supports in Contour (automatic locked up my low power laptop) and it sliced perfectly. Then put in some manual supports and that's when the parameter error pops up. So, it has to be the supports in Contour.
I think this bugs in beta version, you can save scene and load file again.
Re: Parameter incorrect
Hey Reify,
Sorry for the delayed response. Christmas time is insane. I've been busy finishing the last of my orders that needed to be ship.When I get back in my shop later today that file will be sent.
Jim
Sorry for the delayed response. Christmas time is insane. I've been busy finishing the last of my orders that needed to be ship.When I get back in my shop later today that file will be sent.
Jim
Re: Parameter incorrect
Sent.
Please let me know what you find.
Thank you
Jim
Please let me know what you find.
Thank you
Jim
Who is online
Users browsing this forum: No registered users and 68 guests