My prints at 25 are great. Very happy with those. When I move to 42 the prints fail. I use B9 green and the Solus stock settings for it. Should I modify those settings when printing at 42?
Thank you
Jim
Printing at 42
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Printing at 42
You should only have to change your setting in Contour to 42xy. Be sure to change your lens. Calibrate / focus the grid as you did with 25xy.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Printing at 42
If everything is setup correctly and you're getting a failed print, try increasing the exposure time.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Printing at 42
Thank you.
Yes, lens was changed all was set and focused. I'll try to up exposure the next time.
Yes, lens was changed all was set and focused. I'll try to up exposure the next time.
Who is online
Users browsing this forum: No registered users and 6 guests