Heavy ring in 42XY

[ironfonzy]

hi friends!
I need some advice because i'm getting bad results with my rings.My rings are heavy so i switch to the taller build plate in 42xy and 25. As seen on the pictures i try to print, i make the supports in manual...But nothing come in print just the first layers on the build plate.......strange...does make a new support?Thanks for your suggestion..
ironfonzy

[Jewelermdt]

Try tilting up a little more. Did you run ring through NetFab or other STL checker? Move the slider up slowly and look to see if there are any islands that you missed supporting.

[ironfonzy]

Hello
Yes i 've checked it by netfab...i will try with more tilt so

[M-Williams]

I would angle it upward more.