Reify3D Forum

Posted: **Tue May 30, 2017 8:27 pm**

hi friends!
I need some advice because i'm getting bad results with my rings.My rings are heavy so i switch to the taller build plate in 42xy and 25. As seen on the pictures i try to print, i make the supports in manual...But nothing come in print just the first layers on the build plate.......strange...does make a new support?Thanks for your suggestion..
ironfonzy

Posted: **Tue May 30, 2017 10:00 pm**

Try tilting up a little more. Did you run ring through NetFab or other STL checker? Move the slider up slowly and look to see if there are any islands that you missed supporting.

Posted: **Wed May 31, 2017 7:02 am**

Hello
Yes i 've checked it by netfab...i will try with more tilt so

Posted: **Wed May 31, 2017 9:56 pm**

I would angle it upward more.

Reify3D Forum

Heavy ring in 42XY

Heavy ring in 42XY

Re: Heavy ring in 42XY

Re: Heavy ring in 42XY

Re: Heavy ring in 42XY