mongerdesigns wrote:Correct me if I'm wrong Mark, but the money clip part itself is most likely pre-made off the shelf item?
***Totally Stoked!!***
Yes the sterling money clip is just a heavy off the shelf sterling money clip. More cost effective to buy it premade.
Re: ***Totally Stoked!!***
Ah, so did you just use epoxy or something to mount the additional components?
Re: ***Totally Stoked!!***
The Elk and the bezel for the Elk tooth are riveted on from the back. There are 6 rivets on the elk and two on the bezel. The bezel also has a 1mm post. The tooth was drilled and then using colored epoxy glued in place.
Re: ***Totally Stoked!!***
Thanks for sharing your technique Archerm!
Re: ***Totally Stoked!!***
14KW seems like overkill for faux and lab-created gemstones.
Re: ***Totally Stoked!!***
That is what I said but the customer is always right!!!
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: ***Totally Stoked!!***
You should patent that
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 113 guests