***Totally Stoked!!***

[mongerdesigns]

Excellent work as usual and supports. Just so you know Mark, we're training an AI to replicate your supports work.... jk....or am I?

[Archerm]

You know me I am a support minimalist!!

[Archerm]

Been a while since I printed on my 25xy Solus so I fired it up the past few days. Here are a few prints for you to enjoy!

[Archerm]

[Archerm]

[Archerm]

[Archerm]

[Kokos]

Thank you for showing the Rhino picture!!! The prints pictures are often showed. But not the "secret sauce"

Will this extruding technique also work with rings with prongs on the sides?

[Archerm]

Thank you for showing the Rhino picture!!! The prints pictures are often showed. But not the "secret sauce"

Will this extruding technique also work with rings with prongs on the sides?

Yes it will. It is very easy and fast. You just have to be careful trimming them. I trim them about 1mm then lightly sand them down to about .1 mm. Then after casting sand off the rest.

[Kokos]

When I have I ring with prongs, I will try your method. Now I am always messing about.