***Totally Stoked!!***
Hey there Mike, good to hear from you . Thanks, I didn't know he had two....pretty cool. I posted on here earlier viewtopic.php?f=2&t=963 have problems growing a wide band and was wondering if I should have changed resolution.
Re: ***Totally Stoked!!***
A few prints from last week!! Wanted to post some with the contour supports so Emil can see I do use them!! Haaa Enjoy.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: ***Totally Stoked!!***
Ha. Appreciate it Mark. Excellent prints as always.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: ***Totally Stoked!!***
Thanks Emil!! From today 42xy. I like to experiment with the supports. They have to look good!! Haaaa
Re: ***Totally Stoked!!***
A few 25xy prints from yesterday.
Re: ***Totally Stoked!!***
Today's prints!!
Tumbled Castings from the above prints.
Tumbled Castings from the above prints.
Re: ***Totally Stoked!!***
A little Celtic weave!!
Re: ***Totally Stoked!!***
We have been doing lots of multi stone bands lately.
Re: ***Totally Stoked!!***
Very nice prints. Could you share how you replace your film please? Also, how much do you tighten the thumbscrews? I always have a hard time figuring this out. Thank you.
Re: ***Totally Stoked!!***
I use the Optional Film Install Adaptor. You can Find it here.
http://www.junction3d.com/buy/optional- ... ll-adapter
Then This is how I install the film.
https://www.youtube.com/watch?v=ooT3KamfdrI
After the film is installed I tighten the vat all the way down. Then loosen the thumb screws till the vat starts to be loose. Then tighten the thumbscrews 1/4 to 1/2 turn. Then print.
I paint the slots in the thumb screws white so I can keep track of the turns easier. I also mark the vat so it is always installed the same direction.
http://www.junction3d.com/buy/optional- ... ll-adapter
Then This is how I install the film.
https://www.youtube.com/watch?v=ooT3KamfdrI
After the film is installed I tighten the vat all the way down. Then loosen the thumb screws till the vat starts to be loose. Then tighten the thumbscrews 1/4 to 1/2 turn. Then print.
I paint the slots in the thumb screws white so I can keep track of the turns easier. I also mark the vat so it is always installed the same direction.
eangor wrote:Very nice prints. Could you share how you replace your film please? Also, how much do you tighten the thumbscrews? I always have a hard time figuring this out. Thank you.
Who is online
Users browsing this forum: No registered users and 10 guests