I will put the 2 rows of scales back by hand engraving them.
***Totally Stoked!!***
- M-Williams
- Solus Master
- Posts:393
- Joined:Sun Nov 01, 2015 4:45 pm
Re: ***Totally Stoked!!***
Kudos. Phenomenal work !!
Re: ***Totally Stoked!!***
Kind of quiet around these parts??
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: ***Totally Stoked!!***
Everyone has moved to Facebook, Mark. You should post some of your incredible prints in those groups
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: ***Totally Stoked!!***
Kind of quiet 2 !!
Re: ***Totally Stoked!!***
The quality of those castings is amazing. I gotta go back and read up on your methods/techniques.
Re: ***Totally Stoked!!***
rkundla wrote:The quality of those castings is amazing. I gotta go back and read up on your methods/techniques.
Thank you. I haven't changed much. Still using Plasticast 36/100 no type of additives. Curing is the same as I have always done.
Re: ***Totally Stoked!!***
Archerm wrote:Still using Plasticast 36/100 no type of additives. Curing is the same as I have always done.
What oven do you use and are you injecting air into the chamber? Are you using the recommended burnout schedule for Plasticast?
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: ***Totally Stoked!!***
Fantastic as always.
So you're still using the B9 emerald resin?
Have you tried the SolusWax Pro?
So you're still using the B9 emerald resin?
Have you tried the SolusWax Pro?
Who is online
Users browsing this forum: No registered users and 13 guests