Page 39 of 42
Re: ***Totally Stoked!!***
Posted: Wed Feb 06, 2019 5:23 pm
by mongerdesigns
Excellent work as usual and supports. Just so you know Mark, we're training an AI to replicate your supports work.... jk....or am I?
Re: ***Totally Stoked!!***
Posted: Thu Feb 07, 2019 2:38 am
by Archerm
You know me I am a support minimalist!!
Re: ***Totally Stoked!!***
Posted: Wed Nov 27, 2019 1:10 am
by Archerm
Re: ***Totally Stoked!!***
Posted: Wed Nov 27, 2019 1:24 am
by Archerm
Re: ***Totally Stoked!!***
Posted: Wed Nov 27, 2019 1:28 am
by Archerm
Re: ***Totally Stoked!!***
Posted: Wed Nov 27, 2019 1:32 am
by Archerm
Re: ***Totally Stoked!!***
Posted: Wed Nov 27, 2019 1:46 am
by Archerm
Re: ***Totally Stoked!!***
Posted: Wed Nov 27, 2019 3:53 pm
by Kokos
Thank you for showing the Rhino picture!!! The prints pictures are often showed. But not the "secret sauce"
Will this extruding technique also work with rings with prongs on the sides?
Re: ***Totally Stoked!!***
Posted: Thu Nov 28, 2019 1:09 am
by Archerm
Kokos wrote:Thank you for showing the Rhino picture!!! The prints pictures are often showed. But not the "secret sauce"
Will this extruding technique also work with rings with prongs on the sides?
Yes it will. It is very easy and fast. You just have to be careful trimming them. I trim them about 1mm then lightly sand them down to about .1 mm. Then after casting sand off the rest.
Re: ***Totally Stoked!!***
Posted: Thu Nov 28, 2019 1:11 pm
by Kokos
When I have I ring with prongs, I will try your method. Now I am always messing about.