Page 41 of 42
Re: ***Totally Stoked!!***
Posted: Sun Dec 08, 2019 7:00 pm
by Archerm
I will put the 2 rows of scales back by hand engraving them.
Re: ***Totally Stoked!!***
Posted: Sat Dec 14, 2019 3:28 am
by M-Williams
Kudos. Phenomenal work !!
Re: ***Totally Stoked!!***
Posted: Wed Feb 12, 2020 2:55 am
by Archerm
Re: ***Totally Stoked!!***
Posted: Wed Feb 12, 2020 2:58 am
by mongerdesigns
Everyone has moved to Facebook, Mark. You should post some of your incredible prints in those groups
Re: ***Totally Stoked!!***
Posted: Wed Feb 12, 2020 3:00 am
by Archerm
Re: ***Totally Stoked!!***
Posted: Wed Feb 12, 2020 3:04 am
by Archerm
Re: ***Totally Stoked!!***
Posted: Wed Feb 12, 2020 3:47 am
by rkundla
The quality of those castings is amazing. I gotta go back and read up on your methods/techniques.
Re: ***Totally Stoked!!***
Posted: Wed Feb 12, 2020 2:35 pm
by Archerm
rkundla wrote:The quality of those castings is amazing. I gotta go back and read up on your methods/techniques.
Thank you. I haven't changed much. Still using Plasticast 36/100 no type of additives. Curing is the same as I have always done.
Re: ***Totally Stoked!!***
Posted: Wed Feb 12, 2020 3:36 pm
by rkundla
Archerm wrote:Still using Plasticast 36/100 no type of additives. Curing is the same as I have always done.
What oven do you use and are you injecting air into the chamber? Are you using the recommended burnout schedule for Plasticast?
Re: ***Totally Stoked!!***
Posted: Thu Feb 13, 2020 2:18 am
by Jewelermdt
Fantastic as always.
So you're still using the B9 emerald resin?
Have you tried the SolusWax Pro?