Here is my first print of one of my rings.
-
- Novice
- Posts:12
- Joined:Thu Jan 14, 2016 5:46 pm
The print came out better than I really could have expected. I had the same print done by my caster on his SolidScape machine and this print rivaled that one in the detail I achieved for a whole lot less money.
Re: Here is my first print of one of my rings.
Very good first print!!
- M-Williams
- Solus Master
- Posts:393
- Joined:Sun Nov 01, 2015 4:45 pm
Re: Here is my first print of one of my rings.
Beautiful Print !!!!!
Re: Here is my first print of one of my rings.
Very nice and once you print a couple times the lines at the top should disappear as the grease gets worked into the bearings. You can also run the Z arm up and down a few times and this will do the trick too.
Who is online
Users browsing this forum: No registered users and 10 guests