Nice and smooth. Hard to take a good pic bc of the color.
Just Bob
first prints with Maker Juice
Re: first prints with Maker Juice
Looking good Bob
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: first prints with Maker Juice
Those look good Bob. Do you have issues with it sticking to the plate? Seems like I have to make the bases huge so the pieces stay in place.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: first prints with Maker Juice
mongerdesigns wrote:Those look good Bob. Do you have issues with it sticking to the plate? Seems like I have to make the bases huge so the pieces stay in place.
Try dropping your <LiftFeedRate>150</LiftFeedRate> down to something like <LiftFeedRate>25</LiftFeedRate>. It's possible you're pulling too fast. I do all of mine @ 25 LiftFeedRate and 500 ReturnFeedRate and I have zero problems.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: first prints with Maker Juice
sgraber wrote:mongerdesigns wrote:Those look good Bob. Do you have issues with it sticking to the plate? Seems like I have to make the bases huge so the pieces stay in place.
Try dropping your <LiftFeedRate>150</LiftFeedRate> down to something like <LiftFeedRate>25</LiftFeedRate>. It's possible you're pulling too fast. I do all of mine @ 25 LiftFeedRate and 500 ReturnFeedRate and I have zero problems.
Tried slowing it down, the problem is not pulling too fast. Even prints that do stick, I can remove by just sliding them off of the build plate with my finger.
Tried overcuring the base layer, which helps a little, but creates big overflashing and also delamination past the base layers.
P.S. Those settings are useless for Solus users. They are called something else in CW. Please don't confuse people.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 7 guests