Prints from Spain

[studiojoia]

Hi everyone, my name is Jordi and I’m posting from Spain.
This is a print I did on a Nacho Riesco design, it’s the Kraken Ring. I will cast it soon and post more images of it

[Archerm]

Very nice!!

[studiojoia]

More prints, this one designed by Yehardmodels. Printed at 25 microns with protosolus.

[studiojoia]

On more print, again a Nachor Riesco design, printed at 25 microns xy and 25 microns z using protosolus and yellow and emerald hybrid

[studiojoia]

Here's a nice print done at 42xy and 10z. Protosolus it's so easy to build and the quality of the surface is so amazing. I couldn't be happier

[Archerm]

Very nice!! The proto is great for mold making!!

[samatheang]

On more print, again a Nachor Riesco design, printed at 25 microns xy and 25 microns z using protosolus and yellow and emerald hybrid

Hi Jordi, could you share me your exposure time for the 1:1 Yellow Emerald Hybrid and Yellow + 3% Emerald please? Also, which one you prefer between the two hybrids? Thank you very much for sharing.

[studiojoia]

My exposure times are very similar to the Emerald's.
Bottom exposure 13 sec
Layer exposure 2.9 sec
But I have to say that if you want to try this hybrid probably you will need to make adjustments to you exposure, every projector seems to be a bit different.
I adjusted all the exposures on every resin I use, for example my settings for Protosolus are just 4 sec Bottom exposure and 1 sec for the layers.

[studiojoia]

Here are some more prints, I designed this models some time ago and always wanted to print them right, with the Solus I finally can

[mongerdesigns]

Those look great, Jordi!