Reify3D Forum

Hi everyone, my name is Jordi and I’m posting from Spain.
This is a print I did on a Nacho Riesco design, it’s the Kraken Ring. I will cast it soon and post more images of it

Very nice!!

More prints, this one designed by Yehardmodels. Printed at 25 microns with protosolus.

On more print, again a Nachor Riesco design, printed at 25 microns xy and 25 microns z using protosolus and yellow and emerald hybrid

Here's a nice print done at 42xy and 10z. Protosolus it's so easy to build and the quality of the surface is so amazing. I couldn't be happier

Very nice!! The proto is great for mold making!!

studiojoia wrote:On more print, again a Nachor Riesco design, printed at 25 microns xy and 25 microns z using protosolus and yellow and emerald hybrid

Hi Jordi, could you share me your exposure time for the 1:1 Yellow Emerald Hybrid and Yellow + 3% Emerald please? Also, which one you prefer between the two hybrids? Thank you very much for sharing.

My exposure times are very similar to the Emerald's.
Bottom exposure 13 sec
Layer exposure 2.9 sec
But I have to say that if you want to try this hybrid probably you will need to make adjustments to you exposure, every projector seems to be a bit different.
I adjusted all the exposures on every resin I use, for example my settings for Protosolus are just 4 sec Bottom exposure and 1 sec for the layers.

Here are some more prints, I designed this models some time ago and always wanted to print them right, with the Solus I finally can

Those look great, Jordi!