First successful print at 25 micron

[drewbacca]

[drewbacca]

I put the piece in:
ultrasonic (water) 30s
ultrasonic (water + dishwashing soap) 30s
ultrasonic (IPA) 30s

Part was uncured upon taking pictures

[exedebee]

your support very tiny

[drewbacca]

Yes, they are, I haven't printed a large piece yet and found that this support seemed sufficient for all my iterations and testing with this ring. I've probably printed this same ring 3 times to get the results I want, mainly due to the elliptical shape of the first couple.

The support is done in b9c software with spike support. I found them to be very easy to break off while leaving little marks on the piece

[reify]

Good job - looks super smooth.

[drewbacca]

It is, I am very impressed with how smooth it is.