Detail comparison of the Solus and the Form2

[Tom Mathis]

I printed these Loyola championship rings at 25 microns on the Solus and the Form2. I used the castable resin in both printers. Quite a difference in the detail from the Solus on the left and the Form2 on the right. I really couldn't use the Form2 print for this customer. I would have had to send the file off to get printed if it were not for the Solus.

[mongerdesigns]

Wow Tom. That's a huge difference. I'm guessing the laser spot of the form2 is not small enough to get into those tight areas.

[Devlin]

in all fairness here is my sample. Form2 done by another jeweler.
Green on the Solus

I have not cast the form2 resin yet.

[rkundla]

Looked like some overexposure on the Form2. I assume you could manipulate the timing on the Form2, but if that Solus print was with default parameters for the B9 emerald, that is plug-n-play!