Something completely different

Show off your prints.
User avatar
mongerdesigns
Solus Guru
Posts:1950
Joined:Sat Apr 25, 2015 5:16 pm
Location:Los Angeles
Contact:
Re: Something completely different

Postby mongerdesigns » Sat Mar 18, 2017 10:52 pm

Amazing. Just wanted to know more about the project. Great work, Lawrence.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Follow us on Instagram!
https://www.instagram.com/junction3d/
User avatar
nzfinescale
Novice
Posts:61
Joined:Fri Apr 22, 2016 5:13 am

Re: Something completely different

Postby nzfinescale » Fri May 26, 2017 6:32 am

The latest installment of my Solus journey...

This is the cab for a 1:64 scale locomotive. Pipework is 0.3mm minimum, but valve stems are a lot less than that.

The project has a little way to go in terms of detail, but I wanted to test print to prove the concept. This was printed at 30 degrees off vertical, manually supported in Contour. Supports were pretty minimal actually and the result is pretty stunning (if I do say so myself).

Solus Proto (I photoshopped out the brightest orange highlights). Contrary to good advice this had been sitting around in a covered acrylic vat for 6+ weeks. I just gave it a stir and a little top up and it worked just fine.

25/25 with 20 micron layers.

_HLB3845.jpg
_HLB3843.jpg
_HLB3839.jpg
drakon
Posts:3
Joined:Thu Nov 24, 2016 7:52 am

Re: Something completely different

Postby drakon » Fri May 26, 2017 7:07 am

Incredible!
GSJ_NZ
Novice
Posts:33
Joined:Tue Oct 13, 2015 4:15 am

Re: Something completely different

Postby GSJ_NZ » Fri May 26, 2017 7:48 am

That's an awesome print Lawrence, and a cool bit of modelling too!
User avatar
Eoin Rogan
Novice
Posts:23
Joined:Thu May 05, 2016 11:23 am

Re: Something completely different

Postby Eoin Rogan » Sat May 27, 2017 12:35 pm

Fantastic work!

Who is online

Users browsing this forum: No registered users and 7 guests