This is a cool new project by Hector Moran called Jungle Queen. It's a 54mm tall figure. The entire composition including the rocks is about 75mm tall.
Hector asked me to print it on the Solus to show off it's capabilities. The support tips used were 0.1mm so it was very easy to remove and the surfaces are very clean and need very minor post cleanup to remove the tiny support bumps.
Stay tuned for the assembled piece, then casted out of resin and painted.
Jungle Queen by Hector Moran
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Jungle Queen by Hector Moran
Beautiful
- Eoin Rogan
- Novice
- Posts:23
- Joined:Thu May 05, 2016 11:23 am
Re: Jungle Queen by Hector Moran
That's really nice work. I gotta try .1mm attachments now too. Though I find the .2mm attachments can almost be rubbed away without leaving a trace.
Re: Jungle Queen by Hector Moran
Cant wait to see the assembled peace.
Who is online
Users browsing this forum: No registered users and 20 guests