Jungle Queen by Hector Moran
Posted: Tue Mar 21, 2017 11:43 pm
This is a cool new project by Hector Moran called Jungle Queen. It's a 54mm tall figure. The entire composition including the rocks is about 75mm tall.
Hector asked me to print it on the Solus to show off it's capabilities. The support tips used were 0.1mm so it was very easy to remove and the surfaces are very clean and need very minor post cleanup to remove the tiny support bumps.
Stay tuned for the assembled piece, then casted out of resin and painted.
Hector asked me to print it on the Solus to show off it's capabilities. The support tips used were 0.1mm so it was very easy to remove and the surfaces are very clean and need very minor post cleanup to remove the tiny support bumps.
Stay tuned for the assembled piece, then casted out of resin and painted.