Prints by Monger

[mongerdesigns]

Fleur De Lis Ring test print. This ring was only meant to be printed on a solidscape. No more.

[M-Williams]

Solus Rocks. Please how do you clean your prints. do you use alcohol.

[mongerdesigns]

Yes. I use alcohol. 91%.

[rkundla]

Do you soak and swirl or do you use an ultrasonic? I'd think the ultrasonic would help get the uncured resin out from all that detail.

That ring looks fantastic. Nice to see that you can print it without the dissolvable support wax. Did you UV cure that as well?

[mongerdesigns]

Do you soak and swirl or do you use an ultrasonic? I'd think the ultrasonic would help get the uncured resin out from all that detail.

That ring looks fantastic. Nice to see that you can print it without the dissolvable support wax. Did you UV cure that as well?

Thanks Ron. I have a large plastic container full of "dirty" ipa that I agitate the part in for a minute. Then I use a plastic squeeze bottle with clean ipa to wash the part again. (the ipa then goes back into the bottle, and eventually if it gets dirty enough, goes into the "dirty" container, and the bottle gets refilled with brand new ipa).

I have tried the ultrasonic and it works well, but in most cases it's not necessary.

[NF.JP]

https://www.youtube.com/watch?v=ZIadbssZqN0

hi There, here asking.

how much size of top-Radius/Length of Supports?
They look very thin.
I'm worried about that are TOPs printable?

[mongerdesigns]

hi There, here asking.

how much size of top-Radius/Length of Supports?
They look very thin.
I'm worried about that are TOPs printable?

The thinnest parts are 0.2mm in diameter.

[mongerdesigns]

Testing a new prototyping orange resin.

[mongerdesigns]

[M-Williams]

Looks fabulous .Is This the solus new Resin.