Prints by Monger

[Archerm]

Very cool. Are you going to print the whole set!!

[mongerdesigns]

Lol. Not sure.

[Dieter]

Did you print this with Black B9 resin?
If so, can you share the resin profile for this?
Thanks.

[mongerdesigns]

It's not the b9 black. It's the spot a ht with black pigment added. The profile is already in there.

[Dieter]

Have you any idea of the CW profile for the Black B9 resin?
Tried it? Starting tips?

[mongerdesigns]

Haven't tried it, but it's not too difficult to figure out. Start at a certain exposure, maybe 25% less than cherry. If it's overcured, lower a bit more until the details are sharp and accurate.

Remember when making a new profile in cw, don't forget to copy over the gcodes. An easier way it to go the profiles folder, make a copy of the default profile file, rename it, then open cw, choose the new profile and make changes to the exposures.

[mongerdesigns]

Millgrain? no problem. Printed this just yesterday. Minimal supports on the millgrain.

[KennyB]

Wow on the millgrain! I have a model with millgrain that I will be printing soon.

I figured I was going to have to print it without and add it later when I looked at all the red dots on every single bead using Rhino Gold's support tool.

Now, I might just try to print it as is

May I ask what the size of each bead is? My model has .4mm beads.

Still amazed at how great this printer is!

[Archerm]

Love the millgrain. I have done guide a few and the millgrain comes out great.

[mongerdesigns]

Nacho asked me to printer this Tiger Ring on the Solus. Probably went a little overboard with the supports 25 microns XY and 25 microns Z resolution.

Just a quick video using my phone.

https://www.youtube.com/watch?v=OUyUk7jD2eU