Reify3D Forum

I wanted to start this thread, so that I can post prints here instead of keep on making new threads.

It's a part of bracelet link. I left it in the sun to cure for too long and it curved a little.

what if we placed "supports" on the edges to pin it down while it's curing? I don't see any harm and it could prevent it from folding up due to shrinkage on larger sized pieces.

This is the first I am hearing about shrinkage. Is it possible to have shrinkage and how much to anticipate on larger pieces?
I am currently working on 4 pieces that are larger then 50 x 50 and 8 with walls and surfaces .9 to 1.5?

Toddmichael

Playing with the green resin. Printed this snake ring designed by Nacho Riesco.

https://www.youtube.com/watch?v=zCExeMjH9-U

So is that the Solus Resin?

Looking good.

A print I did for a customer, Richard Hall. Great modeling skills. The spoon is 72mm long.

Showing with supports and supports removed.

Very neat!! Spoon ummm

Were all the supports for that spoon done with Creation Workshop, or another tool?

Great detail! What are the other dimensions of the spoon?