Re: Prints by Monger
Posted: Wed Oct 24, 2018 11:18 pm
Cut them using micro scissors close to the surface. Then sand down what's left of the tip. If you make holes, you can also put a drop of resin into the hole, UV cure it, then sand it smooth.
That said, I also try orienting the models in such a way, that the supports are only attached to areas that are not so important, and also by using small supports in other areas.
That said, I also try orienting the models in such a way, that the supports are only attached to areas that are not so important, and also by using small supports in other areas.