Resin exposure
Do we need to be changing the resin exposure time for different model if they are felling? Or should the same setting always work.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Resin exposure
Same setting should work. Unless you have lots of hours on your projector bulb and then you can bump up the exposure a bit.
If you are getting a failed print, please check your supports and the model integrity in netfabb basic.
Also you can contact support and we can help you figure it out.
If you are getting a failed print, please check your supports and the model integrity in netfabb basic.
Also you can contact support and we can help you figure it out.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Who is online
Users browsing this forum: No registered users and 19 guests