Reify3D Forum

Alexpolo wrote:I cant get Lattice to work

Hey Alex, did you figure it out?

Still no go - I freshly imported STL and hit lattice but nothing comes up.

Any clues to why the feature is not visible.

If the object has its own support(s), first set the Lift Height to 0 in the Auto Supports menu.

castings

casting

last one

A good casting machine can make a world of difference. Few extra degrees can overheat your gold alloy and make you casting porous. Casting with a torch is simply hit and miss. Any jeweler who wants to step up his quality work, either has to work with a service bureau or invest in a proper casting machine. In the long run, you will save time, money and a lot of headaches. Marc

make no mistake , I will use these castings , this will take me about 20 min. on my laser for both touch ups , but these are my results , still need to tweek

I grew a few models in the SolusWax. The models came out great but...... I had grown two of the models with soluscast
a day earlier and when I compared them the shrinkage between the two resins was 8 and 12 percent. That's extreme. I'm hoping that the shrinkage occurred during the 20 minutes under my 20 watt UV lamp. I'm growing the same two models to see how they measure without the UV cure. Results posted later today...

Hi Guys,

Anybody have a solution to my problem?