hx19035 wrote:Has this resin been proven reliable in the Solus these days? I remember in the beginning people were complaining about it sticking to the film, etc. It seems like this stuff is more cast-friendly than the Emerald or even the Cherry. Am I thinking in the right direction?
I'm using the B9Y exclusively on my Solus. I lowered the Z-lift to 50, might up it to 75 for less detailed models or those printed flat on the buildplate. I also lowered the exposure a bit. Whatever fails I have now are sticking related but can be solved by doing what was mentioned earlier and by thickening the support diameter from 1.0mm to 1.2 w/ ball points and adding a few manually for "structural" strength using 1.5mm thick w/ 0.6mm regular tips (mostly used on gents ring models). I'm hoping the tilt upgrade kit will help with the peeling process so I can increase the z-lift again. I'd like to stick to a 2.5-3 hour max print time for vertical rings.