Page 6 of 8

Re: ResinWorks EasyCastHD castable resin

Posted: Thu Mar 07, 2019 5:42 am
by rsaldivar
that was my fist time growing and casting it , I did a 45 min. boil in water anniel , a 10 min. uv cure , 2 hours sit time with optima and a straight ramp to 1500 f for a total time in the oven of 6 hours , down to cast temp and this is my results , will try different thing next time , I wanted to see how this would come out using my fastest method that works first , next time I will cure longer and sit time overnight , still not sure which burnout cycle to try next , same one or the b9 green one ??

Re: ResinWorks EasyCastHD castable resin

Posted: Thu Mar 07, 2019 2:49 pm
by Mikkopee
Prints nice, tomorrow first cast. Hope casts well.

Re: ResinWorks EasyCastHD castable resin

Posted: Thu Mar 07, 2019 10:40 pm
by rkundla
rsaldivar wrote:that was my fist time growing and casting it , I did a 45 min. boil in water anniel , a 10 min. uv cure , 2 hours sit time with optima and a straight ramp to 1500 f for a total time in the oven of 6 hours , down to cast temp and this is my results , will try different thing next time , I wanted to see how this would come out using my fastest method that works first , next time I will cure longer and sit time overnight , still not sure which burnout cycle to try next , same one or the b9 green one ??


While it was kind of hard to tell from the photos, how did the non-drilled ring turn out versus the drilled ring? I saw that some of the holes were filled with gold requiring you to spend some time cleaning them up.

Re: ResinWorks EasyCastHD castable resin

Posted: Fri Mar 08, 2019 9:43 pm
by rsaldivar
its as you said , some holes filled , so had to redrill them out , outside of that , every other spot came out perfectly , those filled holes I believe are what happens to letters when you try and cast fonts , in this case just redrill but if they would be fonts , then maybe have to recast and do extreme cure , annel , and react-sun dip ....

Re: ResinWorks EasyCastHD castable resin

Posted: Fri Mar 08, 2019 9:52 pm
by rsaldivar
finished

Re: ResinWorks EasyCastHD castable resin

Posted: Mon Mar 11, 2019 1:15 am
by printcast
Good job!

Re: ResinWorks EasyCastHD castable resin

Posted: Thu Mar 14, 2019 1:22 am
by rkundla
Very nice - and sparkly! :D

Re: ResinWorks EasyCastHD castable resin

Posted: Thu Mar 28, 2019 1:51 pm
by lklutts
I like r this resin. I don't over support. I add 3 supports at the bottom on each side of the ring support. I also am doing them manually.

Re: ResinWorks EasyCastHD castable resin

Posted: Thu Mar 28, 2019 1:54 pm
by lklutts
These supports are what I was talking about. It makes the difference. If you have trouble with it stopping printing above the base and shank I think this is the problem

Re: ResinWorks EasyCastHD castable resin

Posted: Mon Apr 01, 2019 4:49 am
by sabushka
Hi
Any idea where I can get this Resin from. I am in Australia.
Thanks