Help! I messed up

Discuss 3d printing resins
Ellie
Novice
Posts:29
Joined:Wed Jan 06, 2016 2:34 pm
Help! I messed up

Postby Ellie » Tue May 28, 2019 10:23 am

Hey Everyone,

Been running smoothly on my printer since I got the hang of it with very few failed prints,

I just opened a new bottle of B9 Emerald and had transferred it into a bigger round bottle for easier mixing, I figured I'd pour the end of my previous bottle into the new one as there was only a touch in there and am pretty sure I've killed the whole bottle :? forgetting that I'd emptied the bottle weeks ago and transferred the remaining amount into smaller jars for easier mixing and had put 70% IPA in the bottle to clean it before chucking it, which I then poured into my fresh bottle of resin, I realised as soon as I started pouring but it was too late, am I correct in thinking it's ruined? I've just put the lid on and not touched it.
User avatar
mongerdesigns
Solus Guru
Posts:1950
Joined:Sat Apr 25, 2015 5:16 pm
Location:Los Angeles
Contact:

Re: Help! I messed up

Postby mongerdesigns » Tue May 28, 2019 3:30 pm

Pretty sure that’s ruined. The alcohol is used to dissolve and clean the resin.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Follow us on Instagram!
https://www.instagram.com/junction3d/

Who is online

Users browsing this forum: No registered users and 11 guests