Soluswax Pro print lines
Posted: Fri Feb 28, 2020 5:14 pm
Hello forum
I'm using the soluswax pro resin. I have had some print lines in areas of my prints. I see some of you are getting better surfaces then me, unless all those prints are coming from the new Solus Pro printer? Let me know if I need to change my exposure time or something else. I did change my film couple prints ago seeing if that would help. Used the spacer to install new film, visually it looks good. I didn't notice any changes in print quality. Also my prongs are slightly small 1mm prongs are .9
overall my prints are coming out fully usable and casting well. Just seeing if they can be improved
Thanks
I'm using the soluswax pro resin. I have had some print lines in areas of my prints. I see some of you are getting better surfaces then me, unless all those prints are coming from the new Solus Pro printer? Let me know if I need to change my exposure time or something else. I did change my film couple prints ago seeing if that would help. Used the spacer to install new film, visually it looks good. I didn't notice any changes in print quality. Also my prongs are slightly small 1mm prongs are .9
overall my prints are coming out fully usable and casting well. Just seeing if they can be improved
Thanks