lklutts wrote:Not saying I have it down, but getting a grasp on it. I use the green settings for growing. I will post later my machine it's running. I have been curing in uv lamp for an hour or so.Then into my lizard lamp I got from pet mountain. 100 watt, heat,uv and ir. At the height of the box, high tech me, it goes to 150-160. I leave it till it looks cured some an hour, some three. Turn it a couple times to keep it even.
300 1.5 hours
800-2 hours
1350 3 hours
Back to soak temp
vacuum and cast
Thanks, lklutts. That's pretty close to what I have tried, but mind came out very bad. I used 500 for 2 hours, 900 for 2 hours, 1350 for 3 hours, then 1000 for one hour. I have attached some pics of my failed casting below. They were in the same flask with the models that were printed with the Emerald alone, and the Emerald alone came out perfect.
Emerald and Waxcast Hybrid:
Emerald by itself, and they were casted in the same flask with the Hybrid:
The only thing that I did differently from you is curing the Hybrid in water for two hours. Maybe that's problem. What do you guys think?
Thank you.