B9 Yellow 25z profile

[Wdshea]

is there a profile for 25z?

[mongerdesigns]

No. But you can just change the 0.030 to 0.025 and print. Everything else can stay the same.

[Wdshea]

use 3300ms for 25z?

i've been using 2700 for 25z, and it's been working well up until now. i believe due to lumen loss... at 2800ms now.

should i take it higher? 3300 seems like too much.

[mongerdesigns]

The yellow is much better at blocking light. I tested it until a reliable cure was achieved without detail loss.

But you're welcome to try your own settings.

[Wdshea]

i hadn't seen any profile published, so i took a guess.

[mongerdesigns]

i hadn't seen any profile published, so i took a guess.

http://www.reify-3d.com/forum/viewtopic.php?f=13&t=128

[Wdshea]

Sorry, mustve missed the part about using the same settings.

I'm using 3000ms with no issue as of now.

Thanks