Yellow Shinkage

nillard · Postby **nillard** » Fri Nov 11, 2016 5:12 pm

Do you guys do anything to scale the models when growing in Yellow ?
I feel link my models are coming out a little small like .2 or.3mm

Postby **mongerdesigns** » Fri Nov 11, 2016 5:28 pm

The latest version of contour allows you to compensate for the resin shrinkage. It's in File/Setup.

nillard · Postby **nillard** » Fri Nov 11, 2016 5:37 pm

mongerdesigns wrote:The latest version of contour allows you to compensate for the resin shrinkage. It's in File/Setup.

any ideas on where I should start on the %? its a small amount..

Postby **mongerdesigns** » Fri Nov 11, 2016 5:59 pm

For the Scaling module, you enter the measurements that you need to get and what you're actually getting, and the software will compensate.

If you're just going to scale in contour, then it's hard to say for the yellow, but for the emerald, people have seen shrinkage of about 1.5%

Yellow Shinkage

Re: Yellow Shinkage

Re: Yellow Shinkage

Re: Yellow Shinkage

Who is online