Reify3D Forum

Posted: **Fri Jun 15, 2018 2:10 am**

eangor wrote:
M-Williams wrote:Same model with two different resin mix. You can virtually see no layer or hatching lines. as smooth as marble. As impressive as the Emerald / Cherry.

Are those still Epic and Emerald Hybrid, Mike? Epic is too expensive though.

Re: SolusCast: Cracks in heavy model
Postby M-Williams » Tue May 22, 2018 1:10 am

I would suggest the Ember casting resin, 50 % ratio with the Emerald .it is a good alternative and way cheaper compare to other resins. You can get from
https://www.riogrande.com/product/ember ... sin/701285

Posted: **Fri Jun 15, 2018 2:13 am**

The Best Mix in all our trials and failures is 60 Emerald /40 cherry. prints and casts awesome. Marc.

Posted: **Fri Jun 15, 2018 7:13 pm**

I have a brand new bottle of cherry thats 2 yeas old , anyone know If I can still use it to try the 60 / 40 mix Mark is talking about ??

Posted: **Sat Jun 16, 2018 1:19 pm**

rsaldivar wrote:I have a brand new bottle of cherry thats 2 yeas old , anyone know If I can still use it to try the 60 / 40 mix Mark is talking about ??

Just shake it well before use.

Posted: **Sat Jun 16, 2018 3:17 pm**

sorry , what profile again ?

Posted: **Sat Jun 16, 2018 3:40 pm**

Emerald. Good Luck.

Posted: **Sat Jul 21, 2018 7:40 pm**

Hybrid this time with 50% Emerald. The cherry settles way less mixed.