Monogram
Grew in 12 minutes. Cast today. 26mm round
Re: Monogram
Nice casting. I'm experiencing less flashing on 42xy with the default profile using the SolusCast resin. At 25xy, I get flashing similar to yours when printing flat on the buildplate. At 26mm width, I'm guessing you used 25xy, right?
Re: Monogram
Very Nice Casting Len!!
Re: Monogram
way to go Len
- CADjewelrySchool
- Novice
- Posts:71
- Joined:Wed Sep 16, 2015 10:28 am
Re: Monogram
robin wrote:I'm experiencing less flashing on 42xy with the default profile using the SolusCast resin. At 25xy, I get flashing similar to yours when printing flat on the buildplate.
The lamps on the last 8-9 x Vivitek 1186 projectors we have setup for customers have been REALLY bright. I mean way to bright for use with the default exposure settings in the resin profiles.
We have had to reduce the exposure time @ 25XY @ 30microns DOWN from 2.7 to 2.1 sec in B9 Emerald resin, and some of the base exposures are down to 10-11 sec @ 30microns.
Depending on how "tight" your build platform is calibrated to the quartz/ glass, I recommend adjusting the base exposure down in 1 sec intervals till you find the optimal setting to reduce flashing.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Monogram
Hmm. Are you sure, Rik? We use them as is and it works great. Are you setting the projector on ECO mode?
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
- CADjewelrySchool
- Novice
- Posts:71
- Joined:Wed Sep 16, 2015 10:28 am
Re: Monogram
Hi Emil. Yeah I hear you. They are definitely set to ECO. There is flashing at 30z @ 2.7 sec, so we test print and adjust downwards in 0.1 sec steps till we get a clean print with no/little excess resin in the vat after printing.
We are on 240v here in Australia, and I have always thought that made a difference over the US. Maybe not
We are on 240v here in Australia, and I have always thought that made a difference over the US. Maybe not
Re: Monogram
mongerdesigns wrote:Hmm. Are you sure, Rik? We use them as is and it works great. Are you setting the projector on ECO mode?
Yes. I reduce my new 1186 projector exposure time to 3 seconds From 4.5 in 41 microns and base to 20!!!
Who is online
Users browsing this forum: No registered users and 88 guests